To temporarily prevent the cue from starting, hold down the control and option keys (⌃⌥) while opening the workspace.īefore workspace closes, start cue number. The playhead is not affected by this and will remain at the beginning of the cue list as usual. If that cue begins a cue sequence, the sequence will play as normal. If this box is checked and a cue number is entered, that cue will automatically start when the workspace is opened. If the workspace receives another command to panic while it’s in the middle of panicking, everything which is in the midst of fading out will stop immediately. Panic duration is the amount of time it takes for cues to fade out and stop when the workspace receives the command to panic. This can help prevent problems caused by unreliable keyboards or weird KVM switches. Require a “key up” before re-arming GO applies only to the keyboard shortcut assigned to if this box is checked, it compels QLab to wait for the key to be released before accepting another command to. Individual cue triggers and GOs via AppleScript are not protected by this mechanism. After the specified time elapses, the red border will disappear indicating that GOs are once again being accepted.ĭouble-GO protection applies to mouse clicks on the button, pressing the keyboard shortcut for GO ( space, by default), and workspace MIDI, MSC, and OSC messages which directly trigger the “GO” action. If QLab receives a command to GO during this time, the area surrounding the button will flash red to indicate that the command was received, but disregarded. When a number greater than zero is entered, a red border will appear around the button after each GO to indicate that double-GO protection is in effect. Minimum time required between each GO can be set to any duration, including zero, to help prevent accidentally starting cues. The three tabs in General settings apply to workspace-wide behavior. You can also import and export settings from the Workspace Settings sub-menu of the File menu. You can drag a QLab Settings file from the Finder into any patch list, and if the file contains patches of the correct type, those patches will be imported to the workspace without replacing the existing patches.You can drag a section from the list on the left side of the window into a Workspace Settings window belonging to another workspace to import that section of settings.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |